Quick Start Guide

Note
• Turn o󰀨 the main power switch on the robot cleaner before cleaning the robot cleaner.
• Unplug the power cord of the home station before cleaning the charging terminals of the home station.
• In order to maintain the optimum suction power of the robot cleaner, the lter should be cleaned at least once a
month or when dirty.
• To avoid odor, allow the dust bin, cyclonic mesh lter, pre-lter, and HEPA lter to dry completely in a well-ventilat-
ed area out of direct sunlight for at least 48 hours before reassembling.
Cleaning the Dust Bin, Cyclonic Mesh Filter, and Pre-Filter
1. Separate the dust bin, cyclonic mesh lter, and pre-lter from the product body.
2. Clean out the dust particles on the dust bin, cyclonic mesh lter, and pre-lter using a vacuum
cleaner or rinse them under running water.
• Remove any foreign substances on the rubber at the bottom of the dust bin.
• If the dust bin is completely full of dust or the lter is clogged, the suction power may be reduced.
Cleaning the HEPA Filter
1. Separate the HEPA lter from the HEPA lter case.
2. Clean the HEPA lter using a vacuum cleaner or rinse it under running water.
Cleaning the Brush
1. Separate the brush from the nozzle.
2. Remove any foreign substances such as hair and thread from the brush and brush ends.
• Dust may pile up at the brush entrance on the bottom surface. Remove dust from the brush entrance periodi-
cally using a brush or vacuum cleaner.
• If the brush contains foreign substances, the brush may not spin or a noise may occur during operation.
Cleaning the Sensors and Charging Terminals
1. Clean the 3D DUAL Eye, the cli󰀨 detection sensors, and the dust sensor using a cotton swab or a soft cloth.
2. Clean the charging terminals of the home station with a clean, dry cloth.
Maintenance