Owner's Manual

20
Recording Settings
Record Mode Set
You can set the
picture quality
for
recording;
XP
(High Quality),
SP
(Standard Quality),
LP
(Low Quality),
EP
(Extend Quality).
Record
Aspect
When DVD
recording, you
can set the
recording
aspect
ratio to suit the material
you're recording (16:9
or
4:3).
DV
Recording
Audio
You need to set this if
you
have a camcorder
using
32kHz/12-bit sound connected to the front
panel
DV
IN
jack.
Some
digital
camcorders have two stereo tracks for
audio. One is recorded at the time of
shooting;
the
other is for
overdubbing
after
shooting.
On the Audio 1
setting,
the sound that was recorded
while
shooting
is used.
On the Audio 2
setting,
the overdubbed sound is
used.
TV
Recording
Audio
When TV
recording
with
bilingual, you
can choose
audio channel to record.
[Main+Sub]
Main
language
and Sub
language
[Main]
Main
language only
[Sub]
Sub
language only
Auto
Chapter
When
recording
in Video
mode,
chapter
markers are
put
in
specified setting.
You can
change
this interval to
5
minutes,
10 minutes or 15 minutes. If
you
select
[None],
switch off automatic
chapter marking
altogether
with the
[None] setting.
AV2
Recording
You can select the
type
of the
signal
when
recording
video
input signal
from the device connected to the
EURO AV2 DECODER socket.
[Auto]
The video
input signal
will
automatically
follow
the video
signal
received.
[CVBS] Only
for
recording
CVBS
input signal.
[RGB] Only
for
recording
RGB
input signal.
Disc
Settings
Disc Format
If
you
load a
completely
blank
disc,
the recorder will
initialize the disc.
DVD-R: The recorder initialize the disc to Video
mode. The
recording
mode will
always
be Video
mode.
DVD-RW/DVD+RW/DVD+R(DL):
The Initialize
menu will
appears.
Select
[OK]
then
press
ENTER.
DVD-RW disc is initialized to Video mode.
Also,
you
can reformat the DVD-RW/DVD+RW from
the
Setup
menu as below.
1. Select
[Disc Format] option
then
press
B.
2. Press ENTER while
[Start]
is selected.
Format Disc menu
appears.
3. Use
b
/ B to select a desired mode
(VR
Mode or
Video
Mode)
then
press
ENTER.
Confirm
message
will
appear.
For
DVD+RWs,
go
to
step
4.
4. Use
b
/ B to select
[OK]
then
press
ENTER.
It takes a few moments to initialize the disc.
Caution
If
you
want to
change
the disc
format,
everything
recorded on
the disc
will be
erased.