Owner's Manual

18
General Settings
Auto Programming
This recorder is equipped with a frequency
synthesized tuner capable of receiving up to 88
analog channels and 500 digital channels.
Preparation:
Connect the recorder to the desired type of antenna,
as shown in Connecting to the Antenna on page 11.
Note:
Password is needed to access the [Auto Programming]
option if [Lock System] option is set to [On].
1. Select the [Auto Programming] option.
2. Press B to move to the third level.
[Start] icon is highlighted.
3. Press OK ( ) to begin the channel search.
The tuner will automatically cycle through all
available channels in the area and place them in
the tuner’s memory.
You can skip the analog channel scanning by
pressing B.
Note:
If you skip the Auto Setup menu and access the
Setup menu for the first time, you can only set the
[Auto Programming] option. You can set the other
options after finishing [Auto Programming].
Manual Channel Add
This feature manually adds channels.
Note:
Password is needed to access the [Add Channel]
option if [Lock System] option is set to [On].
1. Select the [Program Edit] option then press B .
2. Use v / V to select the [Add Channel] option then
press OK ( ).
3. Use v / V to select [Analog] for analog channel or
[Digital] for digital channel then press B.
4. Use v / V to select a channel number.
Searches for a channel automatically.
Searching stops when the recorder tunes in a
channel.
5. Press OK ( ) to add the channel.