Owner's Manual

16 PLASMA TV
Operation
T
Turning
on the Monitor
urning
on the Monitor
-
When
using
the remote
control,
aim it at its sensor on the Monitor.
Turning
on
the Monitor
just
after installation
Turning
on
the Monitor
(power
cord is
still
connected)
1. Connect
power
cord
correctly.
2. Press the ON/OFF button on the Monitor. At this
moment,
the Monitor is switched to
standby
mode. Press the INPUT SELECT button on the Monitor or
press
the
POWER,
INPUT SELECT button on the remote control and then the Monitor will switch on.
?
Press the ON/OFF button on the Monitor to turn the Monitor on.
1. If
the Monitor
was
turned
off
with the
ON/OFF
button
on
the Monitor
2. If
the Monitor
was
turned
off
with the remote control
and
the
ON/OFF
button
on
the Monitor
?
Press the ON/OFF button on the Monitor and then
press
the INPUT SELECT button on the
Monitor or
press
the
POWER,
INPUT SELECT button on the remote control to turn the Monitor on.
?
When
installing
the monitor
vertically, you
have to
change
the menu
display
mode so that the menus will
appear
correctly
and also to
protect
the monitor from
overheating
(Refer
to
p. 25).
?
Install this monitor
only
in a location where
adequate
ventilation is available.
2 inches
4 inches
2.36 inches
4 inches
4 inches
4 inches
4 inches 4 inches
4 inches
2 inches
To
Mount
on a Wall
Wall mount minimum allowable clearances for ade-
quate
ventilation.
To
Install
on a
Desktop
Pedestal mount minimum allowable clearances for
adequate
ventilation.
Caution
On-Screen Menu
Language
Selection
(option)
On-Screen Menu
Language
Selection
(option)
-
The menus can be shown on the screen in the selected
language.
First select
your
language.
1. Press the MENU button and then use
Δ
/
Ε
button to select the SPECIAL menu.
2. Press the
Γ
button and then use
Δ
/
Ε
button to select
Language.
3. Press the
Γ
button and then use
Δ
/
Ε
button to select
your
desired
language.
From this
point
on,
the on-screen menus will be shown in the
language
of
your
choice.
4. Press the MENU button.