Specification Sheet

LG STUDIO
HOME APPLIANCES
SRFVC2416S
24 cu.ft. InstaView® Door-in-Door®
QUICK INSTALL & CLEARANCES
For full installation directions/clearances please refer to
the corresponding User Manual and Installation Guide.
IMPORTANT
WATER
Select a place where a water supply can be easily connected for the automatic
NOTE
• The water pressure must be 20 – 120 psi or 138 – 827 kPa or 1.4 – 8.4 kgf/cm². If
the refrigerator is installed in an area with low water pressure (below 20 psi), you can
install a booster pump to compensate for the low pressure.
ELECTRICITY
The refrigerator should always be plugged into its own individual properly grounded
electrical outlet rated for 115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes.
This provides the best performance and also prevents overloading house wiring circuits
which could cause a re hazard from overheated wires. It is recommended that a
separate circuit serving only this appliance be provided.
WARNING
• To reduce the risk of electric shock, do not install the refrigerator in a wet or damp
area.
FLOORING
To avoid noise and vibration, the unit must be leveled and installed on a solidly
constructed oor. If required, adjust the leveling legs to compensate for the unevenness
of the oor. The front should be slightly higher than the rear to aid in door closing.
Leveling legs can be turned easily by tipping the cabinet slightly. Turn the leveling legs to
the left to raise the unit or to the right to lower it.
NOTE
• Installing on carpeting, soft tile surfaces, a platform or weakly supported structure is
not recommended.
AMBIENT TEMPERATURE
Install this appliance in an area where the temperature is between 55°F (13°C) and
110°F (43°C). If the temperature around the appliance is too low or high, cooling ability
may be adversely affected.
CHOOSING THE PROPER LOCATION
© 2021 LG Electronics USA, Inc. All rights reserved. "LG Life’s Good" is a registered trademark of LG Corp. All other product and brand names are trademarks or registered trademarks of their respective owners. Design, features and specifications are subject to change
without notice. Non-metric weights and measurements are approximate. Some features may require Internet access. Content and services may vary by product and are subject to change without notice. 11/29/21
2”
BACK
CLEARANCES
DIMENSIONS
1/8”
SIDE
1/8”
SIDE
1”
TOP
▲
!
Make sure the location of the water supply pipe is within the marked range.
▲
!
Before connecting the power, always make sure to ground the product. (If
the product is not grounded, the user may be able to feel the electricity due
to the minute leakage current when touching the refrigerator door handle or
side corner even when there is no issue with the product.)
▲
!
Do not ground the product to gas pipe, plastic water pipe or telephone wire
etc. It can cause electric shock and explosion.
Power connection
The location of the 115V 60Hz power
connector must be located on the rear side
of the product as shown in the picture.
When installing the product, make sure to
check whether the cord is hung on the hook
on the rear side so that it is not pressed on
the refrigerator. Damaged power cord can
cause a re.
Installation space for
water supply pipe
Place the water hose for ice maker and water dispenser as shown in the picture, and
prepare hose to come up from the oor. (Copper pipe with diameter of 5/16”(8mm)
is recommended for the water hose.) If the water pipe and water hose is located
far from the product, bury the water hose on the oor and provide appropriate
treatment.
CONNECTING POWER AND SECURING SPACE FOR WATER SUPPLY PIPE
DIMENSIONS/CLEARANCES/WEIGHTS
A Depth without Door
24 1/8"
B Depth with Handles 30 3/4"
C Depth without Handles 28 3/8"
D Depth (Total with Door Open 90˚) 42 3/4"
E Width 35 3/4"
F Width (Door Open 90˚ with Handle) 42 1/2"
G Width (Door Open 90˚ without Handle) 40"
H Door Edge Clearance with Handle (Not Shown) 4 1/4"
I Door Edge with Clearance without Handle (Not Shown)
J Height to Top of Case
68 7/8"
K Height to Top of Door Hinge 70 1/4"
L Back Clearance 2"
Installation Clearances Sides 1/8", Top 1", Back 2"
Carton Dimensions (WxHxD) 38" x 73" x 33"
ENERGY
Energy Consumption (kWh/Year) 717
ENERGY STAR® Qualified Yes
A
B
L
D
90˚
F
G
C
C
E
J
K
2 1/8"