Owner's Manual
A5
Installing
the
Tilt/Swivel
Base
Turn
off
the
equipment
and
all
attached
options.
Carefully
set
the
monitor
face-down
with
the
underside
facing
you.
Installation
1.Align
the
hooks
on
the
tilt/swivel
stand
with
the
matching
slot
on
the
base
(underside
of
the
monitor).
The
open
hooks
of
the
stand
should
face
the
front
of
the
monitor.
The
matching
slots
are
on
the
first
row
of
slots
showing
2
pairs
of
slots.
2.Insert
the
hooks
into
the
front
and
rear
slots.
The
stand
should
now
fit
flush
with
the
bottom
of
the
monitor.
3.Slide
the
stand
toward
the
front
of
the
monitor,
until
the
latch
clicks
into
the
locked
position.
Now
only
the
bottom
of
the
stand
should
be
movable.
4.Carefully
upright
the
monitor,
taking
care
to
place
the
monitor
down
flatly
on an
even
surface.
NOTE:
To
remove
the
stand,
gently
push
in
the
latch
on
the
bottom
of
the
monitor
and
then
slide
the
stand
toward
the
back
of
the
monitor.
After
sliding
the
stand
back,
lift
off
the
stand
from
the
monitor.