User Manual

Troubleshooting Guide
24
T
roubleshooting Guide
Troubleshooting Tips
To save you time and money, the following page will help answer your questions before service call.
Questions What to do
Dryer won’t run
1. Check dryer is plugged in.
2. Check "Start/Pause" button is pressed.
3. Check door is properly closed.
4. Check room temperature is below 5°C.
5. Check a fuse is blown or the circuit breaker is tripped and replace them.
(Caution : electric dryers generally use two fuses or breakers)
After emptying the water container and cleaning filter during operation,
you must press Start/Pause button, then the dryer will operate again.
It takes a long time
to dry
1. Filter should be cleaned after each load.
2. Check water container is emptied.
3. Select correct cycle setting for fabric type.
4. Check air ventilation grille or rear vents of dryer are not obstructed.
5. Check clothes are not excessively wet.
6. Check the dryer is overloaded.
Clothes are
covered in fluff
1. Check the filter is clean.
2. Check all the items in the dryer are clean.
3. Check all the laundry has been correctly sorted by fabric type.
4. Check the dryer is not overloaded.
5. Check if there are any paper, tissues or other degradable items amongst
the laundry and remove.
The drying time is
not consistent
The drying time for a load will vary depending on the heat setting, the size of
the load, the type of fabrics, the wetness of the clothes and the condition of
the filter.
This is not a malfunction.
Drying time is estimated and will recalculate throughout the cycle as it senses
the dryness of the load.
Water is leaking
Check the water hose or drain hose is properly connected.
The clothes are
creased
Check the dryer is not overloaded. Try a shorter drying time and remove items
whilst they still retain a slight amount of moisture. Use the anti-crease option.
The garments have
shrunk
To avoid shrinkage, please follow the care and use instructions for your
garment, as some fabrics shrink naturally when washed and should not be
placed in a dryer.
Please check the filter is in the dryer.
The filter is not
replaced.
Please replace
the filter.
Insert Filter
Check filter is clean.
Filter is clogged
with lint and dust.
Please clean the
filter.
Clean Filter
Dryer is operating
but “Time Left” in
the display doesn’t
change.