User Manual

Installation Instructions
8
I
nstallation Instructions
Earthing Instructions
This appliance must be earthed. In the event of
malfunction or breakdown, earthing will reduce
the risk of electric shock by providing a path of
least resistance for the electric current.
This appliance is equipped with a earthed cord
and an earthing plug. The plug must be plugged
into an appropriate outlet that is properly
installed and earthed in accordance with
Standard.
Condensed Water Drain
This appliance can be plumbed directly into
the mains waste with the adaptor supplied.
Condensed water will drain away. A plumber
will be required.
Additional Grounding Procedure
Some countries may require a separate ground. In
such cases, the required accessory ground wire,
clamp and screw must be purchased
separately.
Note
- The damper in the door locker assembly
and the packing for the rack assembly in
the drum should be removed before use.
- For better drying performance, Please
keep the rear of product away from wall.
- Do not install the dryer where there is a
risk of frost (dust).
The tumbles dryer may not be able to
operate properly or may be damaged by
freezing of condensed water in the
pump and drain hose.
The dryer should not be installed next to a
refrigeration appliance.
Do not install the Heat pump dryer next to
the high-temperature appliance like
refrigerator, oven or stove etc.
which can cause bad drying performance
and duration, and adversely affect the
proper functioning of the compressor.
The Heat pump dryer gives the best work
with the room temperature(23°)
WARNING
Avoid installing the product around the
place with the heat.
The warm air venting from the rear side of
the dryer must be well ventilated.
If not, this can bring on problems.
WARNING