User Manual

Connecting 15
Connecting
2
1. Select [Connection Setting] option in the
[Settings] menu then press ENTER (b).
2. Read the preparations for the network settings
and then press ENTER (b) while [Start] is
highlighted.
Network will automatically be connected to the
unit.
Advanced Setting
If you want to set the network settings manually, use
w/s to select [Advanced Setting] on the [Network
Setting] menu and press ENTER (b).
1. Use w/s/a/d to select the IP mode between
[Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.
If there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using
w/s/a/d and numerical buttons.
,
Note
2. Select [Next] and press ENTER (b) to apply
network settings.
Network connection status is displayed on the
screen.
3. Press ENTER (b) while [OK] is highlighted to
finish the wired network settings.