Owners manual

OPERATION
7
ENGLISH
Dehumidifying
1 Press to turn on the power.
- It takes 30 minutes of continuous
operation to reach the desired humidity
level the first time the product is used.
- The display shows the current humidity
level.
2 Press / to change humidity.
- The desired humidity level can be set in
5-percent increments from 30-80%.
- The display shows the desired humidity
level while it is being set, then reverts to
the current humidity level after 5
seconds.
- The current humidity level is displayed in
5-percent increments from 25-90%.
If the humidity level is outside the range,
the display continues to show either 25%
or 90%.
3 Press to change the fan speed.
The fan speed has two levels: low or high.
4 Press to turn off the product.
Setting the Timer
1 Press to turn on the power.
2 Press to set the automatic shut off
time.
- Press the button repeatedly to increase
the time until shut off in 1-hour
increments up to 12 hours.
3 Press to cancel the Timer function.
- Press the Timer button repeatedly until
the Timer light turns off.
Safety Standby Light
- After 23 hours of continuous operation, the
red Safety Standby light turns on for one
hour and the fan and compressor shut off to
prevent product malfunction.
- After an hour with the fan and compressor
shut off, the Safety Standby light turns off
and the fan and compressor automatically
restart.
Bucket Full Light
- Empty the water bucket within three
minutes of the Bucket Full light turning on.
- After the light turns on, the fan operates for
an additional three minutes to remove
remaining condensed water and then the
product shuts off.
- See Emptying the Water Bucket for further
instructions.
NOTE
!
• If the product is restarted immediately
after being shut down, to protect the
compressor there is a 3-minute delay
until the compressor begins operating.
• It is normal for the compressor to cause
the product to vibrate while starting or
stopping.
NOTE
!
Empty the drain water bucket before
setting the Timer function.
If the water bucket becomes full during
the Timer function, the Bucket Full light
goes on and dehumidification stops.