Owner's Manual

19
CLEANING MODES
Pressing 'My Space' on Remote Controller will set the My Space cleaning mode with a voice
message.
For cleaning of particular spaces, select this mode.
The 1st stage:
Use the Remote Controller to manually run the cleaning on outskirts of each cleaning block.
※
This cleaning mode will be accepted when the distance of the start and end position is less
than 1 m.
The 2nd stage:
Pressing the 'Start' button will then make the Robot Cleaner clean the manually outlined area by itself.
※
Upon failure to correctly outline a zone, a voice will announce, which says "Area does not meet the specifi ed conditions. Please
continue to make specifi ed area for cleaning process."
Use the Remote Controller to assign a zone, again.
※
If Zone cleaning is complete, the mode is switched to Auto Clean (ZigZag).
• While recharging, you cannot activate 'My Space clean' mode.
• To change the cleaning mode while Robot Cleaner is in operation, press 'Stop/OK' button first to select a mode
The cleaning will the start from the begining.
My Space Cleaning
Tip
My Space