Installation Manual

13INSTALLATION
ENGLISH
5 Close the oven door.
a Bottom vent trim
NOTE
• When you install the oven door, be careful not to
bump the bottom vent trim.
• Keep oven vents unobstructed. Replace the
bottom vent trim if it becomes bent or
deformed. Never block the vent with plastic or
heat-sensitive items.
Assembling the Bottom Decorative
Trim
a Bottom decorative trim
• After installing the oven in the cabinet, assemble
bottom decorative trim with 2 screws
b (4X10).
Test the Oven Before Use
Each of the functions has been factory checked
before shipping. However, it is suggested that you
verify the operation of the oven once more. Refer
to the Owner’s Manual. Follow the instructions for
the basic check.
• Turn on power supply. The initial signal sound is
heard and the Clock segment appears in the
display.
NOTE
• Depending on the model, some of the following
functions may not be available.
Common
1 Turn on the power supply. The initial signal
sound will be heard.
2 Check the operation of the broil mode.
• When the oven is set to broil, the upper
element in the oven should become red.
After a few minutes, partially open the oven
door. You should feel heat from the oven.
Touch Stop.
3 Check the operation of the convection bake
mode.
• After setting the oven to 350 ℉ / 177 ℃ for
convection baking, the fan inside the oven
should come on with the door closed. Touch
Stop.
4 Check the operation of the bake mode.
• After setting the oven to 350 ℉ / 177 ℃ for
baking, the temperature of the oven in the
display should increase. Touch Stop.
5 Turn on and off the oven light to check that
the lights are in normal condition.
Upper Oven
1 Place a glass bowl filled with water in upper
oven.
2 Turn the microwave on for 1 minute. The
water should be hot.
3 Touch Stop.
en-us_main.book.book Page 13 Monday, June 5, 2023 5:24 PM