3828ER3033L P/No.
Washing Machine OWNER'S MANUAL WD-12270BD Thank you for LG Fully buying a Washing Automatic machine. Please read your owner's manual carefully, it provides instructions on safe installation, use and maintenance. Retain it for future reference. Record the model and serial numbers of your washing machine.
P roduct Feature ■ Direct Drive System The advanced Brushless DC motor without belt and ■ directly drives the drum pulley. Tilted Drum and Extra Large Door Opening large opening make it possible clothing more easily. Tilted drum and extra and unload ■ to load Water Circulation Spray detergent Clothes are solution and water onto the load soaked more quickly and over and thoroughly during cycle. The detergent suds can be removed more easily by the shower during rinse cycle.
W arnings READ ALL INSTRUCTIONS BEFORE USE WARNING! ! For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. IMPORTANT SAFETY INSTRUCTIONS ! WARNING : To reduce the risk of fire, electric shock, or injury precautions, including the following: the washer, follow basic ? ? ? ? Read all instructions before using the washer.
S pecification Transit Name Power : loading washing machine 120V~,60Hz Size : 686 Weigh : 86 kg (190 lbs) : 12 kg (26.46 lbs) Spin speed : 1100 rpm Permissible water pressure : 0.3-10kgf/㎠ (30-1000kPa) Wash supply capacity The appearance and Accessories 4 Front : mm(W)×756 mm(D)×983 mm(H)/1291 mm(D, specifications may door open) max. be varied without notice to raise the units quality.
nstallation I Install or store where it will not be Properly ground exposed temperatures below freezing or exposed governing codes and ordinances. to washer to conform with all To reduce the risk of electric The base opening carpeted floor. shock, do not install the washer in humid spaces. must not be obstructed In countries where there vermin, pay particular are areas attention to to the weather.
nstallation I ■Installation clearances The location must be large enough to fully open the washer door. ■ Washer dimensions 75.6 129.1 cm cm [Vista lateral] 98.3 75.6 68.6 cm cm cm 2.5 68.6 cm 2.5 cm cm [Vista frontal] Most installations ? 10 ■ cm require Minimum installation recessed The a minimum ■ clearance behind the washer. area following spacing Level floor ? for ? installation.
I nstallation Electrical connection 1. Do not use an extension cord or double adapter. supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard. Always unplug the machine and turn off the water supply after use. Connect the machine to an earthed socket in accordance with current wiring regulations. The appliance must be positioned so that the plug is easily accessible. 2. If the 3. 4. 5.
nstallation I This equipment is not designed for maritime use or for use mobile installations such as caravans, aircraft etc. stopcock if the machine is to be left for any length of time (e.g. holiday), especially if there is no floor drain(gully) in the immediate vicinity. When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside. Packaging material (e.g. Films, Styrofoam) can be dangerous for children.
I nstallation Level adjustment 1. Adjusting the washing machine level properly prevents excessive noise and vibration. Install the appliance on a solid and level preferably in a corner of floor surface, the room. 2. If the floor is uneven, adjust the adjustable feet as required. (Do not insert pieces of wood etc. under the Make sure that all four feet are feet) stable resting on the floor and then check appliance is perfectly level.
C are before washing WARNING To reduce the risk of fire, electric shock, or injury to persons, read the operating this appliance. IMPORTANT SAFETY INSTRUCTIONS before 1. Fabric Care Labels Look for a care label on your clothes. This will tell you about the fabric content of your garment and how it should be washed. 2. Sorting To get the best results, sort clothes into loads that can be washed with the wash same cycle. Different fabrics need to be washed in different ways.
U sing The automatic the dispenser dispenser consists of four compartments which hold 1) liquid chlorine bleach, or powdered detergent for prewash and 4) liquid or 2) liquid fabric softener, 3) liquid powdered detergent and color safe bleach for main wash. All laundry products can be added at once in their respective dispenser compartments. They will be dispensed at the appropriate time for most effective cleaning. After loading laundry additives into the dispenser, close the dispenser drawer.
U sing the dispenser 2. Main Wash 3. Detergent Compartment ? ? Add measured detergent compartment for Main wash. Detergent dispenser at the beginning cycle. Either powdered or liquid detergent can be used. Liquid or powdered ? during When using liquid detergent, make sure liquid detergent box and insert are place. Do not exceed the maximum cycle. can cause early dispensing of the bleach which could result in damaged ? clothes.
F Select ■ 1) unction cycles designed Automatic wash load Automatically (weight) for different types of fabric and soil levels. detection: detects the load and estimated time remaining in the optimizes the washing cycle will be displayed. time.
H ow to 1.Power( ? use washer 4. ) Use this button to turn the Power On/Off. Allows the start of any cycle to be delayed for 1~12hours. ? Choose the wash cycle for your load, and then press the Delay Wash button once for one hour or press the button ? 2. ? Delay Wash Cycles Rotate the again select Cycle selector knob to cycle designed for different types to 12 hours in one hour increments. to increase the delay wash time up of fabric and soil levels.
H to ow use (1) Button : Power (2) Dial : Program (3) Button : Start/Pause washer (4) Button (5) Button (6) Button : Delay Wash : Custom Program Wash/Rinse Temp. : 6. Wash/Rinse Temperature ? Select a water temperature based on 7. the type ? of load you are washing. Follow the fabric care label and chart below for ? best results. Suggested ? Wash 167°F (75°C) (50°C) ? Spin Speed Start/Pause( In cold climates, ? ? ? dryer than wrinkling. save ) on. only. button.
ow H to use washer 10. Option 11. EST. TIME REMAINING ? 1) Prewash ? Use this option a) for loads that need 2. ? b) and drain. option the remaining operating, when error code when an error in the has been detected. 12. STATUS INDICATOR Rinse+Spin Use this shows: display the estimated time cycle pretreatment. Adds 16 minutes prewash This to rinse and then spin. ? These cycle lights show which the washer is portion operating. of the 3. Extra Rinse ? ? 13.
M aintenance Before cleaning the washer interior, the electrical power cord to avoid electrical unplug shock to avoid electrical shock hazards. When of the disposing cut off the mains appliance, door lock to prevent young children being trapped cable, and destroy the plug Disable the inside. The water inlet filter " -" detergent - message will blink error If your water is very hard become on the control panel when water does not enter the drawer. clogged.
M ■ aintenance Cleaning ? The 1 the dispenser Pull the Dispenser may need to be cleaned 2 dispenser drawer out until it stops. due to periodically build-up. 3Remove the bleach on additive the liquid detergent box, softener Press down the lock tab laundry and bleach inserts from insert. their compartments. Remove the drawer.
aintenance M ■ The water circulation nozzle ? ■ Clean the water circulation nozzle, if Cleaning clogged. your washer 1. Exterior Proper care of your washer The outside of the machine can extend its life. can be cleaned with warm water and a neutral, non- abrasive household detergent. Immediately wipe off any spills. Wipe with a damp Try not to damage the surface with sharp objects. IMPORTANT: Do not use methylated spirit, cloth. solvents or similar products. 2.
T roubleshooting guide This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. When the machine does not function properly or does not function at all, check the following points before you contact your service provider. Possible Cause Symptom Rattling and clanking noise ? Solution Foreign objects such as coins safety pins maybe in drum or or Stop washer and check drum and drain filter.
T roubleshooting guide Possible Cause Symptom Washer does not start ? Electrical power cord may not plugged in or connection be Solution Make plug fits tightly sure in wall outlet. may be loose. ? House fuse blown, circuit Reset circuit breaker breaker Do not increase fuse tripped,or a power outage has occurred. If problem is a replace capacity. or fuse. circuit overload, have it corrected ? Water supply tap is not turned Turn by a qualified electrician. on water supply tap.
T roubleshooting guide Possible Cause Symptom ? ? ? ? ? ? ? ? ? Water Water supply is not adequate in area supply taps are not completely open. Water inlet hose(s) are The filter of the inlet kinked. hose(s) are Solution Check another tap in the house. Fully open tap. Straighten hose(s). clogged. Check the filter of the inlet hose. Drain hose is kinked Clean and The drain filter is Clean the drain filter. or clogged. clogged. straighten the Load is too small.
of Warranty erms T What Is Not Covered: ? ? ? ? Service trips to your home to teach you how to If the product rating plate. is connected to any voltage If the fault is caused by accident, neglect, If the fault is caused by factors use the product. other than that shown misuse or on the Act of God. other than normal domestic use or use in accordance with the owner's manual.