Owner's Manual

10
nstallation
I
Level
adjustment
Concrete
floors(tile...)
Wooden floors
1.
Adjusting
the
washing
machine level
properly prevents
excessive
noise and vibration.
Install the
appliance
on a solid and level floor
surface,
preferably
in
a
corner of the room.
2. If
the floor is
uneven,
adjust
the
adjustable
feet as
required. (do
not
insert
pieces
of wood etc. under the
feet)
Make sure that all four feet are stable and
resting
on the floor and
then check that the
appliance
is
perfectly
level.
(use
a
spirit level)
After
the
washer is
level,
tighten
the
lock
nuts
up
towards
of
the
base
of
the
washer. All lock
nuts must
be
tightened.
Diagonal
Check
When
pushing
down
the
edges of
the
washing
machine
top plate
diagonally,
the
machine should
not
move
up
and down
at
all.
(Please,
check
both
of
two
directions)
If
machine rocks when
pushing
the
machine
top plate diagonally, adjust
the
feet again.
?
The installation surface must be
clean,
dry
and level.
?
Install washer on a flat hard floor.
?
Before
placing
the washer on
tiles,
apply
a rubber mat under the feet.
Do not let the feet of the washer
get
wet. If feet of the washer
get
wet,
slipping may
occur.
?
Wooden
floors are
particularly susceptible
to vibration.
?
To
prevent
vibration we recommend
you place
rubber
cups
under each
foot,
at least 15mm thick under the
washer,
secured to at least 2 floor beams with screws.
?
If
possible
install the washer in one of the corners of the
room,
where the floor is more stable.
Insert the rubber
cups
to reduce vibration.
You can obtain the rubber
cups (p/no.4620ER3001B) from
the LG
spares dept.
Important!
?
Proper placement
and
levelling
of the washer ensure
long,regular
and reliable
operation.
?
The washer must be
absolutely
horizontal and stand
firmly
in
position.
?
It must not "Seesaw" across corners under load.
?
The installation surface must be
clean,
free from floor wax and other lubricant
coatings.
Rubber
Cup
NOTE
Timber or
suspended type flooring may
contribute to
excessive vibration or load balance errors.