Owner's Manual

8
nstallation
I
Water
supply pressure
must be between
30kPa and 1000kPa
(0.3~10kgf/cm2)
Don't
strip
or
crossthread when
connecting
Inlet hose
to
the valve.
If
the water
supply pressure
is more
than
1000kPa,
a
decompression
device should be
installed.
?
Two rubber seals are
supplied
with
the
water inlet hoses these are
in
order to
prevent
water leaks.
?
Check water
tightness
of
washing
machine connections
by
turning
the
tap
completely
on.
?
Periodically
check the condition of the
hose and
replace
the hose
if
necessary.
?
Make sure that there is no
kink
on the
hose and that
it
is not crushed.
When
your
washer has
two
valves,
?
The Inlet hose which has red connector is
for the hot water
tap.
?
If
the washer has two
valves,
the
energy
is saved
by
using
hot valve.
Washing
Machine is to be connected to the water mains
using
new hose-
sets and that old hose-sets should not be used.
Connecting
water
supply
hose
1.
Do not use an extension cord or double
adapter.
2. If
the
supply
cord is
damaged,
it
must be
replaced by
the manufacturer or its service
agents
or
similarly qualified person
in
order to avoid a hazard.
3.
Always
unplug
the machine and turn off the water
supply
after use.
4.
Connect the machine to an earthed socket
in
accordance
with
current
wiring regulations.
5.
The
appliance
must be
positioned
so that the
plug
is
easily
accessible.
?
Repairs
to the
washing
machine must
only
be carried out
qualified personnel. Repairs
carried out
by
inexperienced persons may
cause
injury
or serious
malfunctioning.
Contact
your
local service center
?
Do not install
your
washing
machine
in
rooms where
temperatures
below
freezing
may
occur. Frozen
hoses
may
burst under
pressure.
The
reliability
of the electronic control unit
may
be
impaired
at
temperatures
below
freezing
point.
?
If
the
appliance
is delivered
in
the winter months and
temperatures
are below
freezing
:
Store the
washing
machine at room
temperature
for a few hours before
putting
it
into
operation.
Electrical connection