Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
22 OPERATION
e Option Buttons
• These buttons allow you to select additional cycle options. Certain buttons also allow you to activate
special functions by pressing and holding the button for 3 seconds.
f Remote Control Sensor
• Use the remote to set the controls without bending down to reach the control panel.
Time and Status Display
a Drawer Lock Indicator
• This indicator lights up when the cycle starts and the drawer is locked.
• The indicator light stays on until the cycle is paused, stopped or has finished.
b Lid Open Indicator
• This indicator lights up when the lid is open. Close the lid, shut the drawer, and press the Start/Pause
button to start the cycle.
• Some models do not have the Lid Open indicator. If the lid is closed and the lid error message is
displayed, call for service.
c Child Lock Indicator
• This indicator lights up when the control panel is locked.
•
[L and the remaining wash time are displayed, in turn, on the time remaining display.
• When this function is set, all controls are disabled except for the Power button.
d Estimated Time Remaining
• When a cycle is selected, the default time for that cycle is displayed. This time will change as options
are selected.
• If the display shows
---, then the time will be displayed after the load sensing has detected the load
size.
• The time shown is only an estimate. This time is based on normal operating conditions. Several
external factors (load size, room temperature, incoming water temperature, etc.) can affect the actual
time.
e Cycle Status Indicators
• These LEDs will blink when a cycle is selected to indicate which stages will run.
• When a cycle is running, the LED for the active stage will blink, and the LEDs for the remaining stages
will remain steady. Once a stage is complete, the LED will turn off. If a cycle is paused, the active stage
LED will stop blinking.
Cycle Guide
The wash cycles are designed for specific types of wash loads. Select the cycle that best matches the load
contents for maximum wash performance and fabric care.