Owner's Manual

17
Washing Course
Washing Course
Add the
laundry
Add the detergent
Close the lid Finish Caution & Note
Used for normal loads, this
mode automatically selects the
most appropriate conditions
and completes the sequence
in one operation. The built-in
sensor detects the size of
the load and the ideal wash
power and wash, rinse and
spin times are set accordingly.
1
Add the appropriate quantity
of Detergent as indicated by
the WATER LEVEL next to
Water Detergent. Or follow
the Detergent manufacturer’s
instructions
The pulsate rotates for
8 seconds to detect the
laundry load,
Then the Waster Level and
the amount of Detergent
to be used will be shown
and water will be supplied.
Water will be supplied
for 2 minutes after
the start of the wash
to supplement the
water the laundry
has absorbed.
When the wash
program ends, the
buzzer will ring for
10 seconds before
the Power goes off
automatically.
If water is already in the tub, or putting
wet laundry into the tub before starting
will increase the Water Level.
With lightweight bulky loads, Water
Level can be set low.
Changes to Water Temperature (Hot/
Cold) and wash level are possible during
operation. (refer to page 14)
Use this program for washing
delicate fabrics such as lingerie
and woolens. (wash only
“water washable” clothes)
Before washing your woolens
check the care label for the
washing instructions. (wash
only water washable clothes)
1
Select the Wool
program on the
Control panel.
Use neutral Detergent
appropriate for the laundry.
When washing woolens use a
mild Detergent recommended
for washing wool.
When setting the Water Level manually,
do not set to Medium to prevent damage
to laundry.
Washing with Hot water may damage
the laundry (Water is set to cold
automatically). Ensure that the load
is under 2 kg.
In order to avoid and reduce wrinkles to
the laundry, the spin cycle may appear
slow. As a result, the clothes may contain
a higher level of moisture or water.
Use this mode when washing
lightly soiled clothes for
a short time. The highly
recommended laundry amount
is under 2.0 kg.
1
Select the Quick
Wash Course
on the Control
panel.
Add the appropriate quantity
of Detergents as indicated
by the Water Level next to
Water Detergent. Or follow
the Detergent manufacturer’s
instructions
When static pressure of water is more
than 2 kgf./cm².
Use Duvet Course when
washing Jeans of different sizes
1
Spread
the jeans
evenly in
the tub.
Select the
Duvet course
on the Control
panel.
Use this Course to increase
rising performance. This
would include underwear and
baby clothes. If someone has
sensitive skin or skin trouble,
use this Course.
1
Select the Extra
Clean Course
on the Control
panel.