Owner's Manual

32
Care and Maintenance
C
leaning and Maintenance
NOTE
NOTE
NOTE
• Before cleaning the filter, the impurities in the water supply hose should be removed.
• Check if water leaks after reassembling. (The Rubber ring is in the cap)
• If the lint filter is torn or damaged, purchase a new one from LG service center.
Do NOT rotate this filter as it pivots out along the bottom edge.
• If you always use Cold water, we recommend that a Warm or Hot wash be used at regular intervals e.g.
every 5th wash should be at least a Warm one.
Cold water washing
• Turn off taps to prevent the chance of flooding should a hose burst.
• Always unplug the power cord after use.
When water supply into the tub is not clean or the filter is clogged with particles (such as sand), clean the
filter in the inlet valve occasionally.
(The figure of power cord and water tap may vary according to the country)
When you have finished
1
Close the tap before turning off
the power. Hot/Cold (Warm) and
then press the [START/PAUSE]
button to briefly start a wash in
order to completely remove all
water pressure from the hoses.
1
1
Place a towel on the floor
under the drain pump
cap. Excess water may
flow out.
Filter
Filter
Guide rib
Cap
2
Turn off the power before
pulling out cord.
3
After removing the
water supply hose pull
out the filter.
Then use a brush to clean
the filter.
4
Replace the filter after
cleaning it.
To Clean the Filter in the Inlet Valve
To Clean the Lint Filter
2
2
Turn the cap counter-
clockwise and pull
it out.
Filter
Filter
Guide rib
Cap
3
3
Remove any foreign
objects and fluff inside
pump casing and from
the filter
Filter
Filter
Guide rib
Cap
64
4
Replace the cap. Insert the
filter along the guide ribs
inside the pump casing.
Filter must face the guide
ribs inside pump casing
and securely turn the cap
clockwise
Filter
Filter
Guide rib
Cap
5
To Clean the Pump casting (for pump model)