Owner's Manual

37
Troubleshooting
S
martDiagnosis
TM
1
Close the washer door, and press the POWER button.
• If you manipulated other button or dial before pressing Tub Dry
button, turn off the power and start again from the beginning.
4
Hold the phone while data is transmitted.
• Keep placing phone to SmartDiagnosis
TM
display while data
for smart diagnosis is being transmitted. The time remaining
for data transmission will be displayed on screen.
• Transmission sound may be irritating. For proper diagnosis, do
not take off the phone. You can press power button to stop
diagnosis function and the sound.
5
After the data transmission is completed, listen to the diagnosis result from the consultant.
• When data transmission is completed, the power is automatically
turned off with “End” display after a few seconds.
2
Place the phone to SmartDiagnosis
TM
display.
• Make sure that the speaking side of
the phone to face SmartDiagnosis
TM
display
3
Long press Water Level button to activate smart diagnosis.
• Place the phone near the
SmartDiagnosis
TM
Display, and
long press Water Label button
until tak tak tak sound.
Note : Before pressing the Water
Level should turn the power button
for reuse if you have made other
operations. If under the condition
" CL" uninstall it, and reconnect
the power
NOTE
Smart Diagnosis is a troubleshooting feature designed to assist, not replace, the traditional method of
troubleshooting through service calls, The effectiveness of this feature depends upon various factors,
including, but not limited to, the reception of the cellular phone being used for transmission, any external
noise that may be present during the transmission, and the acoustics of the room where the machine
is located. Accordingly, LG dose not guarantee that smart Diagnosis would accurately troubleshoot any
given issue.