Owner's Manual

Installation
25
Rubber
packing
Rubber
packing
Fixed sticker
screw
Guide
plate
Connector
Connector
Fixed sticker
Middle
Connector
Middle
Connector
Water
Supply
Hose
Pressing
rod
Pressing
handle
Connector
Middle
connector
Fixed Sticker
Pressing
Handle
Pressing
Rod
Water
Supply
Hose
Separate
Middle connector from Water
Supply
Hose
Separate
Middle connector from the Water
Supply
Hose
by pulling
the
Pressing
Rod and the
Pressing
Handle that is attached to the Water
Supply
Hose
while
pressing
them.
Loosen the fixed nuts to connect the connector to the
tap
Untighten
the
screw
of the connector so that the
tap
can be
placed
in the middle.
Fixing
Connectors to the
Tap
Push the
upper
connector
up
till the rubber
packing
is in
tight
contact
with
the
tap.
Then
tighten
the 4
screws.
Fixing Upper
Connector and Middle Connector
Remove
the fixed sticker in
between
the
Upper
and Middle
Connectors.
Tighten
the connectors
by holding
one connector and
twist
middle
connector to the
right.
Connecting
Middle Connector and Water
Supply
Hose
Press
down
the
pressing
rod of the Water
Supply
Hose
which was
separated
from middle
connector(refer
to
Step1)
and then
join
it to the
middle connector.
Normal
Type
If the
tap
diameter is too
large
or is
square,
untighten
the 4
screws
and
remove
the
guide
plate.
In
case the
tap
is too
large.
Note
Check for the water
leakage
After
connecting
the
hose,
open
the
tap
to check
for
any
water
leakage.
If the connection
leaks,
close the
tap
and start
again
from
step
1.
If
you skip step1,
Water
leakage may
occur.
(Normal
tap
without
thread
&
one touch
type
inlet
hose.)
1
2
3
4
5
6