User Manual

28
Separate Middle connector from Water Supply Hose
1
Separate Middle connector from the Water
Supply Hose by pulling the Pressing Rod and
the Pressing Handle that is attached to the Water
Supply Hose.
(Normal tap without thread & one touch type inlet hose.)
Other Type Non-normal
Middle
connector
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Loosen the fixed nuts to connect the connector to the tap
2
Untighten the screw of the connector so that the
tap can be placed in the middle.
Rubber packing
screw
Fixed sticker
Guide plate
Rubber packing
Fixing Connectors to the Tap
3
Push the upper connector up till the rubber
packing is in tight contact with the tap. Then
tighten the 4 screws.
Connector
Fixing Upper Connector and Middle Connector
4
Remove the fixed sticker in between the Upper
and Middle Connectors. Tighten the connectors
by holding one connector and twist middle
connector to the right.
Connecting Middle Connector and Water Supply Hose
5
Press down the pressing rod of the Water Supply
Hose which was separated from middle connector
(refer to Step 1) and then join it to the middle
connector.
If the tap diameter is too large or is square,
untighten the 4 screws and remove the guide
plate. Then follow Step 1.
In case tap is too large.
Connector
Middle
Connector
Connector
Middle
Connector
Fixed sticker
Pressing rod
Pressing handle
Water Supply Hose
Check for water leakage
6
After connecting the hose, open the tap to check
for any water leakage.
If the connection leaks, close the tap and start
again from Step 1.
If you skip Step 1, water leakage may occur.
NOTE
C
onnecting Water Supply Hose
Installation