Owner’s Manual

13
ENGLISH
INSTALLATION INSTRUCTIONS
Unpacking and removing shipping bolts
When removing the washer from the carton base,
be sure to remove the foam drum support in the
middle of the carton base.
If you must lay the washer down to remove the
base packaging materials, always lay it carefully
on its side.
Do NOT lay the washer on its front or back.
1
Remove the bottom two shipping bolts
with the wrench (included) to fully loosen
all four shipping bolts by turning them
counterclockwise and then pulling them out.
Shipping
bolt
Retainer
2
Locate the four hole caps included in the
accessory pack and install them in the
shipping bolt holes.
Cap
NOTE
y
Save the bolt assemblies for future use. To
prevent damage to internal components,
DO NOT transport the washer without
reinstalling the shipping bolts.
y
Failure to remove shipping bolts and
retainers may cause severe vibration and
noise, which can lead to permanent damage
to the washer. The cord is secured to the
back of the washer with a shipping bolt to
help prevent operation with shipping bolts in
place.