Owner's Manual

INSTALLATION 11
Dimensions and Clearances
A
33 1/4" (84 cm)
B
4'' (10 cm)
C
1'' (0.5 cm)
D
27'' (70 cm)
E
77 1/2'' (196.8 cm)
F
1/4'' (0.5 cm)
NOTE
• Refer to the instructions packaged with the optional
pedestal kit before stacking appliance on pedestal.
• Do not use a drain pan with a pedestal or pedestal
washer installation as it can block the drawer. Using a
drain pan may result in increased vibration and noise
during operation.
Unpacking and Removing
Shipping Material
Remove all shipping materials from the washer for proper
operation and inspect it for shipping damage.
• Failure to remove shipping materials can cause excessive
noise and vibration.
Unpacking Shipping Material
* This feature is only available on some models.
Lift the washer off the foam base.
• After removing the carton and shipping material, lift the
washer off the foam base.
• Make sure the plastic drum support a* comes off with
the base and is not stuck to the bottom of the washer.
• If you must lay the washer down to remove the carton
base b, always protect the side of the washer and lay it
carefully on its side. Do not lay the washer on its front
or back.
Removing Shipping Material
1 Remove the bolt assemblies.
• Starting with the bottom two shipping bolts c , use
the included wrench to fully loosen all 4 shipping
bolts by turning them counterclockwise.
• Remove the bolt assemblies (bolts and retainers)
by wiggling them slightly while pulling them out.
2 Install the hole caps.
• Locate the hole caps d included in the accessory
pack or attached to the back of the washer. Install
the caps in the holes left by the bolt assemblies.
• Once removed, save the bolt assemblies for future
use. To prevent damage to internal components,
do not transport the washer without reinstalling
the shipping bolts. Failure to remove shipping
A
B
C
D
C
E
F
*