Owner's Manual
Table Of Contents
- WASHING MACHINE
- ENGLISH
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- OPERATION
- SMART FUNCTIONS
- Using LG ThinQ Application
- Smart DiagnosisTM Function
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
14 INSTALLATION
2 Hang the end of the drain hose over the side of the
laundry tub.
3 Use the provided tie strap to secure the drain hose
in place.
Leveling the Washer
The drum of the washer spins at very high speeds. To
minimize vibration, noise, and unwanted movement, the
floor must be a solid, level surface.
• Using the washer without leveling it may cause excess
vibration and noise, leading to a washer malfunction.
• Adjust the leveling feet only as far as necessary to level
the washer. Extending the leveling feet more than
necessary can cause the washer to vibrate.
NOTE
• Before installing the washer, make sure that the floor is
clean, dry and free of dust, dirt, water and oil so the
washer feet cannot slide easily. Feet that move or slide
on the floor can contribute to excessive vibration and
noise.
How to Level the Washer
1 Position the washer in its final location.
• Take special care not to pinch, strain, or crush the
water and drain hoses. If you have a carpenter’s
level a, you can use it to check that the washer is
level. The slope beneath the washer should not
exceed 1 inch, and all 4 leveling feet must rest
firmly on the floor.
2 Adjust the leveling feet.
• Turn all 4 leveling feet in one direction to raise the
washer or the other direction to lower it.
3 Check the level again.
• Push or rock the top edges of the washer gently to
make sure the washer does not rock. If the washer
rocks, readjust the leveling feet.
4 Tighten the locknuts b
• Turn the locknuts counterclockwise and tighten
them when the washer is level.
Using Non-Skid Pads
If you install the washer on a slippery surface, it may move
because of excessive vibration. Incorrect leveling may
cause malfunction through noise and vibration. If this
occurs, install the nonskid pads under the leveling feet
and adjust the level.
1 Clean the floor to attach the non-skid pads.
• Use a dry rag to remove and clean foreign objects
or moisture. If moisture remains, the non-skid
pads may slip.
2 Adjust the level after placing the washer in the
installation area.