Owner's Manual

Placing and Leveling
28
Please ensure that transit restraint has been removed before operating your machine.
If the washer is installed on a uneven,weak or tilted floor causing excessive vibration,
spin failure or “UE” error can happen to it.
It must be placed on a firm and level floor to prevent spin failure.
SETTING SCREW
ANTI-RAT COVER
BACK
Top view of the machine
SETTING SCREW
ANTI-RAT COVER
BACK
more than 10 cm
more
than
2 cm
more than
2 cm
Place the machine on a flat and firm surface which allows proper clearance.
We suggest a minimum clearance of 2 cm to the
right side and left sides of the machine for ease of
installation.
At the rear, a minimum clearance of 10 cm is sug-
gested.
Make sure that the washer is properly Level
Open the lid and look from above to see if it is
same as shown.
Leveling the machine
Lift the front of the washing machine and twist
the Adjustable Leg until the surface bubble is
placed in the center.
1
2
3
NOTE
SETTING SCREW
ANTI-RAT COVER
BACK
SETTING SCREW
ANTI-RAT COVER
BACK
Adjustable legs
Caution
※ Installing the Anti-Rat Cover (option) Insert the anti-rat cover to be firmly fixed from the back or
front of washing machine and screw it
If the power is supplied from a cord extension set or generator, the cord extension set or electrical
portable outlet device should be positioned so that it is not exposed to splashing or ingress of moisture.
MFL69022794(영)_150X210 15. 12. 15. 오후 4:15 페이지 28