User's Manual

INSTALLATION

Accessories

* This feature is only available on some models.

a Cold and Hot Water Inlet Hoses

b Drain Hose*

c Tie Strap*

Specifications

Installation Place

Requirements

Before installing the appliance, check the following

information in order to install the appliance in a

correct place.

Installation Location

• Install the appliance on a flat floor of hard

material that is strong enough to support a fully

loaded appliance. (Allowable slope under the

appliance: 1º)

• Never try to level any uneven floor by putting

pieces of wood, cardboard or similar materials

under the appliance.

• If it is impossible to avoid positioning the

appliance next to a gas cooker or coal burning

stove, an insulation (85 X 60 cm) covered with

aluminium foil on the side facing the cooker or

stove must be inserted between the two

appliances.

• Ensure that when the appliance is installed, it is

easily accessible for a service technician in the

event of a breakdown.

• Additional clearance for the wall should have 10

cm for the rear and 2 cm for right and left side.

Model WTG9020V WTG9020W WTG9020MB

Power Supply 220 - 240 V~, 50 Hz

Dimension

(Width X Depth X Height)

632 mm X 670 mm X 1020 mm

Product Weight Approx. 44.5 kg

Permissible Inlet Water Pressure 30 - 600 kPa