User's Manual

INSTALLATION

Connecting the Hose to the

Water Tap

Connecting Screw-Type Hose to Tap with Thread

Screw the hose connector onto the water supply

tap. Hand tighten only with the aid of a soft cloth.

NOTE

• After connecting the water inlet hose to the

water tap, turn on the water tap to flush out

foreign substances (dirt, sand, sawdust, and etc.)

in the water lines. Let the water drain into a

bucket, and check the water temperature.

Connecting the Hose to the

Appliance

Screw the water inlet hose to the water inlet valve

on the back of the appliance.

• Do not connect the hose to the hot water supply

for models with one water inlet. Connect to the

cold water supply only.

NOTE

• After completing connection, if water leaks from

the hose, repeat the same steps. Use the most

conventional type of tap for the water supply. In

case that the tap is square or too big, remove the

guide plate before inserting the tap into the

adaptor.

Installing the Drain Hose

Before connecting the drain hose, check your drain

hose model and choose the correct instruction.

Installing the Drain Hose with

the Elbow Bracket

The drain hose must not be placed higher than 120

cm above the floor. Water in the appliance may not

drain or may drain slowly.

• Securing the drain hose correctly will protect the

floor from damage due to water leakage.

• If the drain hose is too long, do not force the

drain hose further into the drain outlet. This will

cause abnormal noise.

• When installing the drain hose to a sink, secure it

tightly with the some string, cable tie, or chain.

NOTE

• The discharge height should be approximately

90 - 120 cm from the floor.

FP