Installation guide

C50.V2120.02E-1
Case components
Installation Guide
Rubberized grommets
for liquid cooling
system’s tubing
Patented
tool-less 5.25”
device mounting
120mm fan
Removable
3.5” HDD module
Multi-media ports
Hardware list
Longer vision thumb screw(3)
for mother board mount
Thumb screw(54)
for HDD
Rubber ring(50)
for HDD
Shorter vision thumb screw(9)
for mother board mount
Screw(5)
for PSU mounting
USB3.0 to USB2.0
convertor (1)
Screw (20)
for converter & spare parts
5.25" mounting
bezel
Fan controller
Door key is attach to
the accessory box
Front door
with lock
Side panels installation
Remove the side panel. Adding a lock to secure the
hardware.
Loose the screw and pull the
latch to release the side panel.
1
Push to release
Slide the HDD into the HDD
cage
Install the screws to the HDD
with anti-vibration rubber rings
Mounting bracket
for SSI CEB/EEB M/B
PCI card holder/A (11)
Thumb screw(11)
for PCI card holder
Follow the arrow to remove
the fan for HPTX M/B
installation
Converter (1)
3.5" to 2.5" x 2 drive bays
Nut(3)
for stand off
Box(1)
for spare parts
Stand off bolt (3)
for motherboard (spare parts)
Removable
PSU tray
for cable management
Clamp (1)
Thumb screw(1)
Close the gate to secure the
HDD.
Insert HDD, secured with
thumb screws.
3.5” HDD module installation 2.5" HDD installation
Use one
3.5" to 2.5" x 2 converter
Screw (8)
for 2.5” HDD
Buzzer (1)
Cable tie (2)
for cable
Install the screws to the HDD
with anti-vibration rubber rings
Secure the stand-off bolts on the M/B tray which
match with the M/B fix points, place the M/B
on the copper bolt, fasten with the thumb screws
to secure.
for SSI CEB/EEB
The oval hole on M/B tray
designed for special server
boards, please use nut to
hold the copper bolt in place.
Note: For area where hard to
reach use the long
thumb screw
!
!
!
PCI card holder/B (4)
For 2.5" HDD x 2
Removable
120mm fan cover
Notice:
Loosing six
thumb screws
Slide out M/B tray
2.5" HDD module
installation
3.5” HDD module
installation
Removable
fan mounting
Remove 5.25" mounting bezel
2
Air inlet below PSU
with air filter
Removable
front fan & air filter
Side panel lock
140mm fans
with air filter
Power switch
Reset switch
Metal casters
with brake
For 2.5" HDD x1
Removable
3.5” HDD module
For 2.5" HDD x1
Screw (12)
for 2.5” HDD
VGA card pillar
For 2.5" HDD x1
Slide out M/B tray
Vent for USB3.0 cable
HDD can slide into the cage by
either side.
(HDD port in front or back)
Notice: