User's Guide

ManualsBrandsLibelium Comunicaciones Distribuidas ManualsElectronicsWireless sensor node for the Internet of Things

Table Of Contents

-20-

Step 10: Upload the code

Now, press the upload button and see messages coming out from IDE. During a while you will see message “uploading to I/O

board”.

Figure : Uploading a code for Waspmote Plug & Sense!

Wait a few seconds until the process ends and check there are no error messages, just “Done uploading” message.

Step 11: Open the Serial Monitor

If uploading processes are successfully completed, open Serial Monitor to see the output of the uploaded code.

Figure : Opening Waspmote IDE serial monitor

When uploading processes are nished successfully, do not forget to screw the protection cap of USB connector to avoid its

damage.