Instructions / Assembly

ManualsBrandsLiberty Pumps ManualsBattery Back-up Sump SystemsStorm Cell 1/3 HP Back-Up Pump System with Night Eye Alarm

4. Electrical Connection

Float Switch

20A Fuse Pump Baery

After installing the 442 battery backup pump and float, the StormCell

system setup is quite simple. Images of the user interface and

charger are shown below, along with a charger LED indicator reference.

1. Mount the StormCell

charger Liberty PN’s (10 Amp - 1061000 or 25 Amp - 1066000) using the (2) supplied self tapping

screws and, if required, the (2) supplied drywall anchors (3/16” hole required). Ensure that the charger located in an accessible

location, within the range of the 8’ pump power and float cords included with your StormCell

system.

2. Mount the StormCell

user interface in an accessible location at eye-level, ensuring that it is within the range of the blue RJ45

cable through which communication between the interface and charger will occur.

3. Locate the battery box within the range of the battery charger cables (pre-installed on the StormCell

charger).

4. Connect your pump power cord and float switch cable to the StormCell

charger. Also, connect the blue RJ45 communication

cable into the charger and the user interface.

5. Connect the charger battery leads to the battery (or batteries, in the case of a 442-25A), ensuring that the (-) connection is made

first, followed by the (+).

6. Install a 9V battery into the StormCell

user interface, noting polarity as shown on the interface label.

Note: A 9V battery must be installed in the device at all times to ensure proper operation.

7. Plug in the StormCell

battery charger. The system should now be operational.

8. If the device is NightEye

enabled, refer to the NightEye

quick-start guide.

Reset

StormCell UI

High Water Float

Pump On Float

Check Fuse

Pump Ready Float

Pump Failure

Pump Run

AC Power

Charged

Charging

Alarm

Baery Reversed

Above: View of StormCell

user interface, showing connec-

ons to be made to the charger

Le: View of StormCell

charger, showing reset locaon,

RJ45 connecon locaon, and LED funconality.

Below: View of StormCell

442-10A charger showing oat

connecon, pump power cord connecon, baery cable con-

necon (442-25A will have two baery cable connecons),

and fuse locaon (which is shielded by a protecve cover).

442-25A’s use a dierent fuse, than is shown below, read

label to locate the fuse and its size.

+ 9V Baery -

StormCell

Aux.

Contacts

1—2—3

Terminal Connecons:

1: Normally Open

2: Common

3: No Connecon