Pump Specifications FL100 Series Submersible Effluent Pump 2” Solids handling Flow (Liters Per Minute) 38 76 114 151 189 227 265 303 341 379 416 30 90 27 80 24 70 21 60 18 50 15 40 12 30 9 20 6 10 3 0 0 0 10 20 30 40 50 60 70 80 90 Flow (GPM) FL100_P1 R12/20/2012 ©Copyright 2012 Liberty Pumps Inc. All rights reserved. Specifications subject to change without notice.
FL100-Series Dimensional Data FL100_P2 R12/20/2012 ©Copyright 2012 Liberty Pumps Inc. All rights reserved. Specifications subject to change without notice.
FL100-Series Electrical Data HP VOLTAGE PHASE SF FULL LOAD AMPS FL102M-2 1 208-230 1 1.00 12 FL102M-3 1 208-230 1 1.00 12 FL102A-2 1 208-230 1 1.00 FL102A-3 1 208-230 1 FL103M-2 1 208-230 3 FL103M-3 1 208-230 3 FL104M-2 1 440-480 3 FL104M-3 1 440-480 FL105M-2 1 575 FL105M-3 1 575 MODEL THERMAL OVERLOAD TEMP STATOR WINDING CLASS CORD LENGTH FT DISCHARGE AUTOMATIC 28.5 120˚C 248˚F B 25 1.5 OR 2" NO 28.5 120˚C 248˚F B 35 1.5 OR 2" NO 12 28.
FL100-Series Specifications 1.01 GENERAL: The contractor shall provide labor, material, equipment, and incidentals required to provide (QTY) centrifugal effluent pumps as specified herein. The pump models covered in this specification are Series FL100 single phase or three phase effluent pumps. The pump furnished for this application shall be model ______________as manufactured by Liberty pumps. 2.01 OPERATING CONDITIONS: Each submersible pump shall be rated at 1 hp_____ volts _______ phase 60 Hz.
.01 MOTORS Single phase motors shall be oil filled, PSC, class B insulated NEMA B design, rated for continuous duty. Three phase motors shall be polyphase. At maximum load the winding temperature shall not exceed 130 degrees C unsubmerged. Since air filled motors are not capable of dissipating heat they shall not be considered equal. The single phase pump motor shall have an integral thermal overload switch in the windings for protecting the motor. 6.
13.01 FACTORY ASSEMBLED TANK SYSTEMS WITH GUIDE RAIL AND QUICK DISCONNECT DISCHARGE ______ Guide factory mounted rail system with pump suspended by means of thread on quick disconnect which is sealed by means of nitrile grommets or o-rings. The Discharge piping shall have a check valve. The Discharge piping shall be schedule 80 PVC and furnished with a PVC shut-off ball valve. The Tank shall be wound fiberglass or roto-molded plastic. An inlet hub shall be provided with the fiberglass systems.
