Install Manual

10
WARNING: Risk of Electric Shock
This pump must be properly connected to power following the National
Electric Code (NEC). Failure to follow these warnings will void the warranty
and could result in a fatal electric shock. A green LED will indicate if power
is available. The pump is supplied with a grounding conductor. To reduce
the risk of electric shock, be certain that it is connected to ground. Discon‑
nect power before working on or around the pump.
1. This pump is supplied with lead wires and intended to be hardwired using
a junction box or other approved enclosure. This pump includes a conduit
connector for using 1/2” flexible metal conduit. The conductors must
be enclosed in conduit in accordance with local authority, NEC, and
Occupational Safety and Health Act (OSHA).
2. The installation should be performed by a qualified technician. Comply
with national and local electrical and plumbing codes as well as local
authority,NEC, and OSHA.
3. Pump conductors must be connected to voltage specified on the pump
nameplate. Power conductors must be connected to a constant source
of power (not a fan or other device that runs occasionally). The power
conductors provided must be enclosed in conduit and hardwired inside a
junction box or other approved enclosure.
4. Final installations should always be inspected and approved by the
local authority of jurisdiction per requirements set forth by the same local
authority.
6. Electrical Connection and Safety Switch
Installation
6
SYSTEM
T-STAT
Com
Run
OVEFLOW SWITCH
24V 1A Max
YRGB
YBRGB
SYSTEM
T-STAT
Com
Run
OVEFLOW SWITCH
24V 1A Max
YWGB
YBWGB
120V
230V