Safety Data Sheets (SDS)

SAFETY DATA SHEET
The Libman Company LIBMAN READY TO USE GLASS CLEANER (1 GALLON #1064 / 32OZ BOTTLE #2068)
The Libman Company Page 4 of 7
SECTION 7. HANDLING and STORAGE
7.1 PRECAUTIONS FOR SAFE HANDLING:
To prevent skin and eye contact under the foreseeable conditions of use, wear appropriate protective clothing and
safety eyewear. When handling, do not eat, drink, or smoke. Wash thoroughly after handling. Handle in a well-
ventilated work area.
7.2 STORAGE AND HANDLING PRACTICES:
Keep away from strong oxidizing agents. Keep in cool, dry, well-ventilated area in closed containers. Protect containers
from physical damage.
7.3 SPECIFIC USES:
Cleans Glass, Mirrors, Chrome, and many more hard surfaces without streaking.
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
8.1 EXPOSURE PARAMETERS:
Chemical Name CAS# ACGIH TLV OSHA TWA
Water 7732-18-5 Not Listed Not Listed
Ethyl Alcohol 64-17-5 TWA 1000 ppm
TWA 1000 ppm
(1900 mg/m3)
8.2 EXPOSURE CONTROLS:
VENTILATION AND ENGINEERING CONTROLS: Use with adequate ventilation to ensure exposure levels are
maintained below the limits provided above.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying
with OSHA regulations found in 29 CFR Subpart I (beginning at 1910.132) or equivalent standard of Canada, or
standards of EU member states (including EN 149 for respiratory PPE, and EN 166 for face/eye protection), and those
of Japan. Please reference applicable regulations and standards for relevant details.
RESPIRATORY PROTECTION: Not required for properly ventilated areas. Maintain airborne contaminant concentrations
below guidelines listed above, if applicable. If necessary, use only respiratory protection authorized in the U.S. Federal
OSHA Respiratory Protection Standard (29 CFR 1910.134), equivalent U.S. State standards, Canadian CSA Standard
Z94.4-93, the European Standard EN149, or EU member states.
EYE PROTECTION: Safety glasses or goggles are recommended. If necessary, refer to U.S. OSHA 29 CFR 1910.133,
Canadian Standards, and the European Standard EN166, Australian Standards, or relevant Japanese Standards.
HAND PROTECTION: Chemical resistant gloves are required to prevent skin contact. If necessary, refer to U.S. OSHA
29 CFR 1910.138, the European Standard DIN EN 374, the appropriate Standards of Canada, Australian Standards, or
relevant Japanese Standards.
BODY PROTECTION: Use body protect appropriate to task being performed. If necessary, refer to appropriate
Standards of Canada, or appropriate Standards of the EU, Australian Standards, or relevant Japanese Standards. If a
hazard of injury to the feet exists due to falling objects, rolling objects, where objects may pierce the soles of the feet or
where employee’s feet may be exposed to electrical hazards, use foot protection, as described in U.S. OSHA 29 CFR
1910.136.
SECTION 9. PHYSICAL and CHEMICAL PROPERTIES
9.1 INFORMATION ON BASIC PHYSICAL AND CHEMICAL PROPERTIES:
APPEARANCE (Physical State) and COLOR: This product is a blue liquid.
ODOR: Minty fragrance
ODOR THRESHOLD: Not Available
pH: 6-8
MELTING/FREEZING POINT: Not Available
BOILING POINT: Not available
FLASH POINT: Not applicable
EVAPORATION RATE (n-BuAc=1): Not Available
FLAMMABILITY (SOLID, GAS): Not Applicable
UPPER/LOWER FLAMMABILITY OR EXPLOSION LIMITS: Not Available
VAPOR PRESSURE (mm Hg @ 20°C (68F): Not Available
VAPOR DENSITY: Not Available
RELATIVE DENSITY: Not Available
SPECIFIC GRAVITY: Approximately 1