User's Manual

LS5B User Manual
Libre Wireless Technologies User Manual: LS5B, Ver. 1.0 Page 47 of 89
Libre Confidential
Action
1. Reboot the Speaker and
2. Trigger WAC / SAC using the Setup Button (Press and Hold
for three seconds) in LS EVK or through Message-Box 142.
Result
LS-Enabled Speaker switches from DDMS Mode to Non-DDMS
Mode and connects to the AP configured earlier.
6.2. Wireless Network Setup Using Webserver
6.2.1. Webpage Method
This method is used if the device is already connected to a network.
To setup wireless network via Webpage proceed as below
Step 1. Execute command #netcfg in the device terminal to know the device IP
For Example, 10.0.1.13
Step 2. Enter the IP in the address bar of your browser, For Example, 10.0.1.13.
The webpage shows the Network status of the currently connected Access Point.
Figure 6-12: Network Status
Step 3. In Select Your Network section, Select the Access Point (AP) to be connected,
from Select your Network drop-down list and Click Save
Device reboots and connects to the new network and acquires new IP