User's Manual

LS5B User Manual
Libre Wireless Technologies User Manual: LS5B, Ver. 1.0 Page 51 of 89
Libre Confidential
Figure 6-16: Configure Network Manually
End--
6.3. Wireless Network Setup Using WPS Push-Button Method
6.3.1. WPS Trigger from Command Line
To setup a wireless network using WPS proceed as below
Step 1. On system boot, enter the command #wpa_cli wps_pbc in device terminal
Step 2. Trigger (Press Once) Setup button in the Access Point.
Device connects to the Network of the Access Point.
Step 3. To know the newly acquired IP execute command #netcfg in the device
terminal
End--
6.3.2. WPS Trigger from LUCI
You can setup a wireless network for the LS-Enabled speaker, using the LUCI Message-Box
#141. Message-Box #141 is used by Host to trigger WPS mode.
For more information see section 6 in LUCI Technical Note,
LibreWirelessTechNote - LS_Light_Weight_Universal_Control_Interface.