User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 14 of 81
Libre Confidential
3.1.1. Network Method
To update the binary file (Application-Image or Single-Image) on the LS6 module over
network proceed as below
Make sure the LS6 EVK and your laptop / PC is connected to the same
network.
Steps
Step 1. Execute command #netcfg in the device terminal to know the device IP
For Example, 10.0.1.13
Step 2. Enter the IP in the address bar of your browser.
For Example, 10.0.1.13
Step 3. In the Firmware upgrade section, Select Method as Network and Click
Upgrade
Figure 3.2.1-1: Firmware Upgrade Method Selection