User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 28 of 81
Libre Confidential
5. Key Button Functionality
5.1. Setup Button (WAC / SAC / DDMS)
The Setup (SW5) button in LS-EVK is configured to trigger WAC / SAC after the LS module
boots up as below.
Press and Hold the setup button on the LS EVK for 3 seconds, to come out of the
DDMS mode.
- LS EVK connects to the AP or the SSID configured earlier.
- To connect the LS EVK to different AP or SSID, Press and Hold the
setup button on the LS EVK for 3 seconds again, to trigger SAC /
WAC.
- If the LS EVK was not configured to any AP, Press and Hold of
setup button triggers SAC / WAC.
- This state is stored in non-volatile memory and even after boot-up,
the state is retained.
For more information on DDMS Stand-Alone mode and Home-Network mode refer to DDMS
Usability guide (Android / iOS) available in LibreSync Document Portal.
5.2. LED Status
LED D18, in the LS6 EVK is used to identify the DDMS Connection Status.
Blinking LED indicates LS6 EVK is in transition to DDMS and connection is not
set.
Solid LED indicates LS6 EVK is in DDMS mode and is configured as one of the
DDMS-Node (Speaker-Master or Speaker-Station).