User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 29 of 81
Libre Confidential
6. Network Configuration
The network configuration method supported in LS-Module is
Wireless Network Setup Using WAC Method
Wireless Network Setup Using SAC Method
Wireless Network Setup Using Webserver Method
Wireless Network Setup Using WPS Push Button Method
6.1. Wireless Network Setup Using WAC and SAC
6.1.1. Wireless Network Setup Using WAC
To setup a wireless network using Wireless Area Controller (WAC) proceed as below
Step 1. Press and hold the Setup button for 3 seconds on the EVK
Step 2. On an iOS device running iOS7, go to Settings > Wi-Fi > SET UP NEW DEVICE
The WAC speaker is listed. For example, LibreSync <MacID>
Figure 6.1.1-1: WAC Speaker Listed
Step 3. Select the speaker / EVK and tap NEXT