User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 36 of 81
Libre Confidential
Scenario 1
Precondition
LS-Enabled speaker is not connected to AP.
Action
WAC / SAC is triggered using the Setup Button (Press and Hold for
three seconds) in LS EVK or through Message-Box 142.
Result
LS-Enabled Speaker enters WAC / SAC mode for Network
Configuration.
Scenario 2
Precondition
LS-Enabled speaker is connected to AP.
Action
WAC / SAC is triggered using the Setup Button (Press and Hold for
three seconds) in LS EVK or through Message-Box 142.
Result
LS-Enabled Speaker enters WAC / SAC mode for Network
Configuration.
Scenario 3
Precondition
LS-Enabled speaker is not connected to AP.
Action
1. Reboot the Speaker.
2. Configure the speakers to DDMS SA-Mode (refer to DDMS
usability guide).
3. Trigger WAC / SAC using the Setup Button (Press and Hold
for three seconds) in LS EVK or through Message-Box 142.
Result
LS-Enabled Speaker switches from DDMS Mode to WAC / SAC
mode for Network Configuration.