User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 38 of 81
Libre Confidential
Scenario 7
Precondition
LS-Enabled speaker is in DDMS HN-Mode and was connected to
AP earlier.
Action
1. Reboot the Speaker and
2. Trigger WAC / SAC using the Setup Button (Press and Hold
for three seconds) in LS EVK or through Message-Box 142.
Result
LS-Enabled Speaker switches from DDMS HN-Mode and enters
WAC / SAC mode for Network Configuration.
6.2. Wireless Network Setup Using Webserver
6.2.1. Webpage Method
This method is used if the device is already connected to a network.
To setup wireless network via Webpage proceed as below
Step 1. Execute command #netcfg in the device terminal to know the device IP
For Example, 10.0.1.13
Step 2. Enter the IP in the address bar of your browser, For Example, 10.0.1.13.
The webpage shows the Network status of the currently connected Access Point.
Figure 6.2.1-1: Network Status