User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 40 of 81
Libre Confidential
Figure 6.2.1-3: Network Configuration using Static IP
Use any IP address from the Access Point IP’s address range which is
not assigned to any client device already.
Device reboots and connects to the network and acquires the static IP as defined.
Step 4. To know the IP address of the device, execute command #netcfg in the
device terminal
End--
6.2.2. LS-Configure Method
To setup wireless network using LS-Configure proceed as below
Step 1. Press and hold the Setup button for 3 seconds on the EVK to trigger LS-
Configure
Device enters “AP” mode and is available in the Wi-Fi network list as LS-Configure_xxxxxx