User's Manual

LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 42 of 81
Libre Confidential
Step 3. To know the newly acquired IP execute command #netcfg in the device
terminal
Figure 6.2.3-1: Configure Network Manually
End--
6.3. Wireless Network Setup Using WPS Push-Button Method
6.3.1. WPS Trigger from Command Line
To setup a wireless network using WPS proceed as below
Step 1. On system boot, enter the command #wpa_cli wps_pbc in device terminal
Step 2. Trigger (Press Once) Setup button in the Access Point.
Device connects to the Network of the Access Point.
Step 3. To know the newly acquired IP execute command #netcfg in the device
terminal
End--