User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 43 of 81
Libre Confidential
6.3.2. WPS Trigger from LUCI
You can setup a wireless network for the LS-Enabled speaker, using the LUCI Message-Box
#141. Message-Box #141 is used by Host to trigger WPS mode.
For more information see section 6 in LUCI Technical Note,
LibreWirelessTechNote - LS_Light_Weight_Universal_Control_Interface.
6.3.3. WPS Trigger from Key Button
(TBG)
6.4. I-Device Wi-Fi Settings Sharing
Host-MCU requests the LS enabled device to share the Wi-Fi settings over Message-Box #
126. On request from HOST-MCU, iOS device shows a pop-up message to the user to “Ignore”
or “Allow” the settings sharing.
Figure 6.4.1-1: Wi-Fi settings sharing
To share Wi-Fi setting tap Allow
To cancel sharing Wi-Fi settings tap Ignore