User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 46 of 81
Libre Confidential
7. Features
7.1. Libre APP for Android
LUCI enables user to remotely, control the LibreSync LS6 enabled product using the Libre
Application for android. The application can be used to browse DLNA-DMS in the network,
SD Card connected to device and other online radio stations such as vTuner and TuneIn , and
stream music using the DMP feature supported by LS6.
For more information on using Libre APP refer
LibreWireless-Usability_Guide_Dynamic_Direct_Multi-Node_Streaming
7.2. DDMS
A Wireless Dynamic Direct Multi-Node Streaming (DDMS) Zone is a group of nodes, (DDMS
enabled speakers) chosen dynamically by an end user to synchronously play audio from a
given content source.
This group of speakers can play music from any Audio Source synchronously without any
delay between the nodes. Each group can consists of two or more nodes.
DDMS Group is created in two mode
Home-Network Mode – A state in which DDMS-Nodes creates a Sound-Scene, by
connecting to the Access-Point (AP) in the Home-Network.
The Audio Source (smartphone) streaming the audio should be connected to the
same AP.
Stand-Alone Mode - A state in which DDMS-Nodes creates a Sound-Scene, by
connecting to the Master using the SSID of Sound-Scene in SA-Mode. In this state
there is no Access-Point (AP) or home infrastructure present.
The Audio Source (smartphone) streaming the audio should be connected to the
same SSID of the Sound-Scene in SA-Mode.