User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 55 of 81
Libre Confidential
Step 4. Tap the Speaker from the list
Speaker connects to the Miracast and streams the music from the current playlist
Step 5. Close the Miracast Screen
End--
For details on scenarios of Miracast Mode Switching with other Different Modes
(WAC/DDMS), and Miracast Source Switching with other Different Sources, refer to
“LibreWirelessTechNote-Miracast_Mode_and_Source_Conversion” document available in Libre
Portal.
7.11. SD-Card Playback
LS supports Audio Playback from SD-Card. User can select the content source from SD-Card
to stream music on a LS-Enabled speaker.
The seek operation support for SD-Card Playback is available from Mid-January, 2015
Release (LS6-v6027) and Onwards.
7.12. i-Device playback over USB
LS supports audio playback from i-Devices over USB. User can select the content source from
an iOS device to stream music on LS-Enabled speaker.
Apple devices which support iAP2 protocol (Apple devices with lightning connector except
iPod nano 7g) can be connected to LS device and playback can be done.
When Host-MCU is Not-Present (in LS-EVK)
If the NV-Item hostpresent is set to '0' , connect the apple device and press PLAY icon on the
UI of the apple device to start the playback.
To Disable NV-Item hostpresent
#setenv hostpresent 0