User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 58 of 81
Libre Confidential
Toggle Between Favourites
Use the Previous, and Next keys to toggle between favourites. You can also send the Play
Control commands Over LUCI via Message-Box 40.
7.14. USB Playback
LS supports audio playback from USB. User can select the content source from an USB drive
to stream music on LS-Enabled speaker.
7.15. TCP / IP Tunneling
TCP/IP Tunnelling is a unique feature supported by LS modules. Tunneling enables a Host
MCU to communicate with other network devices over UART. The Host MCU can build their
own proprietary protocol using LUCI tunneling.
For more information on TCP / IP tunneling refer LUCI document
LibreWirelessTechNote - LS_Light_Weight_Universal_Control_Interface
7.16. Wi-Fi Scan Result
Wi-Fi Scan result enables you to list the available access point. This feature is intended to be
used by the APP developers to list the available networks in the APP for configuration.
To use the feature, in the address bar of your browser enter the IP address followed by
/scanresult.asp.
7.17. Device Name Configuration
You can define a friendly name to LS-Platform enabled device. To define the friendly name
proceed as below.