User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 62 of 81
Libre Confidential
Step 3. In Select Your Network drop-down list, select Switch to Wi-Fi mode and
Click Save
Figure 7.17.2-1: Switch to Wi-Fi Mode
LS module reboots automatically.
End--
7.19. Pair / Share credentials
Pair functionality enables LS-Enabled speaker to pair (join) with other LS-Enabled speaker.
Share functionality allows the LS-Enabled speaker to share its Wi-Fi credentials with other
LS-enabled speakers.
For Example: If there are two LS-Enabled speakers, called LS-Speaker A and LS-Speaker B,
then LS-Speaker A with pair enabled, can join LS-Speaker B only when LS-Speaker B is
enabled with share.
Pair / Share functionality is possible, only when both the LS-Enabled speakers
are in the same mode. That is, when both the LS-Enabled Speakers are in Home-
Network mode or both the LS-Enabled Speakers are in Stand-Alone Mode.
For information on using PAIR / SHARE commands see “LibreWirelessTechNote -
LS_Light_Weight_Universal_Control_Interface” available in Libre Portal.