User's Manual

LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 81 of 81
Libre Confidential
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. This modular must be installed and operated with a minimum
distance of 20 cm between the radiator and user body.
If the FCC identification number is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. This exterior label can use wording such as the
following: Contains Transmitter Module FCC ID: 2ADBM-LS6-N22S or Contains FCC ID:
2ADBM-LS6-N22S
when the module is installed inside another device, the user manual of this device must
contain below warning statements;
1 This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
i. This device may not cause harmful interference.
ii. This device must accept any interference received, including
interference that may cause undesired operation.
2 Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The devices must be installed and used in strict accordance with the
manufacturer's instructions as described in the user documentation that comes with the
product.
Any company of the host device which install this modular with limit modular approval
should perform the test of radiated emission and spurious emission according to FCC part
15C : 15.247 and 15.209 requirement, Only if the test result comply with FCC part 15C :
15.247 and 15.209 requirement，then the host can be sold legally.