User's Manual

Librestream Onsight 1000/2000/2500 User Manual Onsight Device Basic Operation
2 Onsight Device Basic Operation
Before operating the Onsight device, you must read the Onsight
Regulatory and Safety Guide.
Note that the Onsight device shuts itself off when battery power is low.
x If the unit is on, and an operator is using it in an active call, a warning message appears so that the operator
has time to plug the Onsight device into the external power adapter, or end the call before the Onsight device
shuts off.
x If the unit is in Standby, it simply shuts itself off.
x If the unit is off, it cannot be started when the battery is low.
2.1 Charging the Battery
Before charging the battery for the Onsight 2000Ex/2500Ex, you
must read the Onsight 2000/2500 Regulatory and Safety Guide.
New batteries must be charged prior to first use.
Î To charge the battery:
1. Plug in the external power adaptor and allow the battery to charge until the orange battery indicator
extinguishes (up to eight hours).
2. The internal battery charger will shut itself off to prevent overcharging once the battery is fully charged.
Î To check current battery levels:
1. Press the Display button
once and check the Session Information Status bar at the bottom of the
Viewfinder which shows the battery level.
2. See paragraph 4.1.3, Session Information, on page 31 for more information on Viewfinder Features & Display
Modes.
2.2 Inserting or Replacing the Battery
Before using this device for the first time you must install and charge the battery.
17