User's Manual

Librestream Onsight 1000/2000/2500 User Manual Onsight Device Basic Operation

4. When installing the new battery, align the contact edge of the battery with the small recess lines in the battery

compartment, keeping the opposite end of the battery up.

Recess lines (2)

Alignment pins (2)

5. Slide the battery towards the compartment door and push downward to place in the battery well.

6. When the battery is sitting flat on the compartment floor, slide the battery towards the compartment door until

seated.

7. Close the battery compartment and tighten the screw. Note that the door will not close if the battery is not fully

inserted, and the device will not start if the door is not properly closed.

8. Attach the Power Sled or I/O Sled and use the external power adapter to charge the battery until the orange

LED turns off (up to 8 hours).

The device will not operate on the external adapter alone. You must have a

battery installed.